Skip to content

The Crew Behind the Show

9 courses, in the order they are meant to be taken. You can start anywhere, and they build.

How to read the course codes
  • -00 means start here.
  • -01, -02 are steps on one path, in order.
  • A letter (-T1, -P2) marks a track. Tracks run in parallel: take any track you like, in any order, without taking the others.
  • -99 is the capstone. Take it last.

Start here

  1. CREW-00

    Cables and Connectors

    Start here. Everything else in this series assumes it.

    The first thing a new crew member is handed, and the thing every course in The Crew Behind the Show assumes. Pick up a cable on a broadcast truck, a stage or an arena floor and say what it carries, what connector is on each end and why, how far it can run, what breaks it, and what must never be plugged into it. The course reads makers' spec sheets and free reference pages to teach impedance and why a cable that fits can still be wrong; SDI on 75-ohm coax and BNC from SD to 12G, and where HDMI and DisplayPort stop; reference, timecode and return video; triax, the SMPTE hybrid fiber camera cable and tactical fiber; single-mode and multimode fiber, LC, SC and ST, inspection, loss budgets and laser safety; and balanced audio, the XLR family that carries mic audio, party-line intercom and DMX, AES3, word clock and MADI. Then network cable, Dante and ST 2110; power connectors, what the rules say about who may connect what, and when to stop and call a licensed electrician; DMX, RS-422, tally, USB and 50-ohm RF coax; and the craft of coiling, labeling, testing and fault-finding, ending in a hands-on capstone on video. Vendor products are worked examples, not endorsements. Every lesson that needs a broadcast engineer's or a stage electrician's sign-off says so at the top.

The path

  1. CREW-01

    Rigging for Stage and Broadcast Crews

    Step 1 on the single path through this series.

    For stagehands, arena crew and sports-broadcast utility technicians who work near rigging and need to know exactly where their job stops. The course reads the federal rules that govern the work, the stage-edge exemption in OSHA's fall-protection rule and what it does not say, what a personal fall arrest system must do, the parts and hitches of a sling, why gear with no legible rating tag is never used, how chain, wire rope, web and round slings and hooks are checked and pulled from service, and why spreading a sling's legs raises the tension in each one, including two misprinted worked examples in the Army's own rigging manual. Two state investigations of crew deaths, a fall through a false ceiling and a ballast weight that slid off a telehandler's forks, are read as cases, linked with the news coverage. It ends with the real routes to qualification: ETCP certification, IATSE training and the registered apprenticeship title Rigger. It is not a rigging qualification, it does not teach anyone to fly a load, and it never gives a capacity number. Every lesson whose safety claims need a qualified rigger or a practitioner says so at the top. The first course in The Crew Behind the Show series.

  2. CREW-02

    Sound Craft

    Step 2 on the single path through this series.

    For anyone who wants to come back from a park, a hall or a set with a recording they can trust and defend. The course starts with listening, the way National Park Service technicians are trained to listen, and with what a decibel and a spectrogram actually say. It reads OSHA's noise rule and NIOSH's recommended limit as two documents with two numbers, sets up a recorder that does not quietly change the sound, and plans a field session around season, wind and the recordist's own footprint. It records a performance with two microphones and says what that setup cannot do, reads 1980s Army television courses for the kit, the lavalier and the meter, and marks plainly where film-set practice needs a practitioner. It reads hooves, hail, rain and thunder made by hand in a 1913 Paris stage manual, writes cues the way a 1928 federal radio script did, treats the story of Foley's name as an open record, and reads a sound's license and a person's release before using either. It ends with what O*NET says about sound work. It is not a qualification, a hearing-conservation program or legal advice, and every lesson that needs a qualified reviewer or a practitioner says so at the top. The second course in The Crew Behind the Show series.

  3. CREW-03

    Light on Set

    Step 3 on the single path through this series.

    For theater volunteers, school and church AV teams, student filmmakers, small broadcast crews and anyone with a phone and a window who wants to light a stage, a studio or a set with what is already there. The course starts by reading the light in a room before touching anything, then works out hard and soft light from three things a lamp maker's research physicist named in 1916: where the source is, how large it looks from the subject, and how bright the surroundings are. It bounces light off walls and ceilings and counts the whole path, fills a shadow with white paper, takes light away with a dark surface, uses the sun and a window as the key, and places a key, a fill and a back light the way two Army manuals did, including where they disagree. It reads a household bulb's box for its color temperature, looks at what a theater, a television studio and a film set each ask of light, and ends on the safety floor: hot lamps, cords and circuits, and the homemade dimmers and stovepipe spotlights of the 1920s, shown only as what the rules forbid. It is not a qualification or an electrical course, it teaches no one to hang a light, and every lesson that needs a qualified reviewer or a practitioner says so at the top. The third course in The Crew Behind the Show series.

  4. CREW-04

    Cinema-look camera rig

    Step 4 on the single path through this series.

    For camera operators and broadcast crew who want to build or run the handheld, shallow-focus camera that live sports broadcasts use for close, film-style shots. The course starts with the look itself: what depth of field is, why a bigger sensor and a faster lens make it thinner, and how Fox Sports put the rig on air at an NFL game on December 20, 2020, before Marquee Sports Network, FOX Deportes, BaylorVision, CBS, ESPN and Netflix built their own versions. It then takes the rig apart one piece at a time: the camera body, the lens, and the gimbal, including its modes, its balancing routine and what the league rule books say about working a sideline. The second half joins the rig to a live show: the three kinds of wireless video link and their delay counted in frames, range and crowded bands, frequency coordination and who may transmit, what the truck does with your picture, shading, tally, intercom and the questions to ask the engineer. It ends with a troubleshooting method and pre-show checklist, and three builds priced on October 21, 2026, with what to own, what to rent, and which compromises are fine for film and documentary work but not for a network sideline. Every fact is cited, and claims an earlier draft got wrong are taught as corrections. Lessons that need a qualified reviewer before release say so at the top. The fourth course in The Crew Behind the Show series.

  5. CREW-05

    Arena transmission: how a game leaves the building

    Step 5 on the single path through this series.

    For broadcast crew moving toward technical and transmission work, and for anyone who finished Break Into Sports & Media Broadcasting and wants to know what happens to a game's pictures after the truck. The course follows a live game's video, audio and data out of the arena. It starts with the map: who sends what to whom on game night, using the NBA's High-Speed Arena Network as a documented, cited example of a league arena network, including its 2026 fourth generation, its history, the replay center and tracking systems beside it, and the jobs the league posts to run it. Next come what those jobs ask you to know about IP networks and multicast, defined from the standards that define them, where to learn more for free, and how to build a home lab that is honest about its limits. Then video over IP: the parts of SMPTE ST 2110, how SDI maps onto them, how streams are described and connected, bandwidth math worked step by step, and packet size and pacing. The last three sections cover timing with PTP and two-path protection with ST 2022-7, fiber and the physical layer (where to learn it free, what certifies it, and a starter kit), and monitoring and fault isolation under a clock: feed check-in, sorting a fault into source, transport or receiver, seeing packet loss, status calls and reports, and a mock game night in a home lab. Every fact is cited, guesses are labeled as guesses, and no team or venue is named. Lessons that need a qualified reviewer before release say so at the top. The fifth course in The Crew Behind the Show series.

  6. CREW-06

    Renting Out Production Gear: the Owner-Operator's Business

    Step 6 on the single path through this series.

    For camera operators, sound mixers and other crew who own production gear, or are thinking about buying it, and want to know whether renting it out makes sense. The course reads the market from published price lists and platform terms: rental houses, a peer-to-peer platform, and the owner-operator who brings a kit and charges a kit fee. It teaches how to choose what to own and what to keep renting, how to buy new or used and keep the records an insurer and the IRS ask for, how to price day, weekend and week rentals against the real market (and why a percentage-of-replacement-value rule can mislead), how damage waivers differ from insurance, how to protect gear against damage, theft and non-return, how to prep, check out, check in, clean, repair and retire it, and how to do break-even math honestly, with your own labor counted separately from what the gear earns. Depreciation, expensing and tax records are taught at a beginner's level, with a plain instruction to talk to a tax professional. No lesson promises income, and every rate is a dated example. Lessons on contracts, insurance and taxes are marked for a qualified reviewer. Part of The Crew Behind the Show series.

  7. CREW-07

    The Sideline's Other Crew

    Step 7 on the single path through this series.

    Beside every broadcast crew at a big game works a second crew that most viewers never see: the technicians who run the tracking cameras, the officials' replay systems and the injury video that medical staff review. This course explains what a stadium's tracking array is and who uses its output; how review systems serve the licensed medical people who keep athletes safe, and why the video crew never makes a medical call; how the NFL, the NBA, the NHL, MLB, tennis, football (soccer), cricket and college conferences use replay, tracking and measurement under their own rules; what a technician's game day looks like, hour by hour, from the postings that describe it; which jobs the leagues and vendors post, what they ask, what they paid as posted and how the postings describe moving up; and where and when those postings open, what to practice and how the work is contracted. It ends with a written capstone: a game-day runbook for one role, every step cited from the public record, or a comparison of two vendors' systems from their own pages. It is job-shaped knowledge for crew who already know a truck or an arena. It does not teach medicine, and it does not teach any vendor's operator screens. Vendors and leagues are cited worked examples, not endorsements, and every lesson that needs a systems technician's or an athletic trainer's sign-off says so at the top.

  8. CREW-08

    The Show Crew

    Step 8 on the single path through this series.

    A live game on television is made by a crew most viewers never see. This course takes you into the sports truck and the studio control room and goes chair by chair: who answers to whom, and who owns the rundown and the clock; the A1 and the A2 in audio, the intercom and the IFB, and the mix; the V1 and the V2 in video, shading, scopes and robotic cameras; the replay operator, the playout operator and the TOC; the graphics operator, the broadcast associate who checks names and numbers, the real-time systems crew and the virtual enhancement operator who places the first-and-ten line; the utility, camera operators, stage manager and lighting director on the floor; how the chairs talk on comms, the director's calls and the counts, the checks before air, and one play followed through every seat; and how these jobs are posted and paid, with dates. Every role is described from sources you can open: a network's production manual, the directors' guild agreement, makers' pages and dated job postings, quoted as posted. It teaches each chair at a working level. It is not any maker's operator certification, makers are cited worked examples rather than endorsements, and every lesson that needs a sign-off from someone who has held the chair says so at the top.